- ページ 6

ペットケア製品 DogWatch Performance SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DogWatch Performance Series 14 ページ。 Hidden fence systems
DogWatch Performance Series にも：インストレーション・マニュアル (10 ページ), オーナーズマニュアル (16 ページ), オーナーズマニュアル (13 ページ)

plugged into the transmitter, the Loop Monitor Display (LMD) light will turn on. If the

boundary wire is broken or the signal is interrupted, the LMD light will go out and

an audible warning will sound. If the LMD light is out, consult your Dealer. You

should also check around your property for a visible broken wire.

6. Loop Monitor Display (LMD):The Loop Monitor Display provides a visual indi-

cation of the status of your boundary signal. On traditional boundary wire con

figurations each number on the scale represents the boundary signal distance in

feet, that is being broadcast from each side of the wire. (Minimum setting is one

[1] foot.) A significant change (drop) in signal range could indicate a partial wire

break or other boundary wire problem. Contact your dealer for troubleshooting tips

or to schedule an appointment.

Note: For non-traditional wire configuratons where the boundary wires may be

close to one another, the LMD may not measure the boundary signal accurately

in feet, but is a visual setting reference point. Your DogWatch dealer will explain

the LMD setting and your actual signal range.

7. Range: The radio signal is transmitted from the boundary wire in all directions. The

signal is adjusted by the digital range control on the transmitter to create a sig-

nal field on each side of the wire. The recommended signal field width is 6-10

feet. Your DogWatch Dealer will adjust the radio signal distance according to

the personality and traits of your dog. Consult your DogWatch Dealer first

before making any adjustments yourself.

Signal Field: The signal field has two areas. When your dog first enters the sig-

nal field, he will receive an audible warning. If he continues further into the sig-

nal field, he will receive a correction. The audible area is approximately the first

10% of the total signal field. To prevent your dog from entering the signal field

and remaining in the audible area causing depletion of the battery, the receiver

will transition from an audible warning to a short warning correction after a period

of 15 seconds. This will activate regardless of the mode switch setting, but will

not activate if the receiver is in the "Audible Only" Training Level

(see Phase 1: page 15)

8. Training Mode: This turns the stimulation on and off. If your dog enters the signal

field with the Mode "on," (Full Function) he will receive an audible warning followed

by a correction. When the Mode is "off," (Audible Only) he receives an audible only

warning (see "Signal Field" description above). The Mode should only be turned

off if your dog has been thoroughly trained with the Mode "on" and consistently

responds to the audible warning alone. We recommend that the Mode be left in

the "on" or "Full Function" position.

9. Rate: This adjusts to three levels (1-slow, 2-medium, 3-fast). When your dog

gets a correction, he receives it in a series of pulses. Increasing the Rate means

that he will receive a greater number of pulses per second.

Note: On the back of each transmitter are four small switches. These switches set your transmit-

ter to the correct broadcast frequency. Your dealer will set these switches for your system. Do NOT

change these settings. They are for DEALER USE ONLY.

.................................