- ページ 2

ペットケア製品 DogWatch System 1200のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DogWatch System 1200 10 ページ。 System
DogWatch System 1200 にも：取扱説明書 (16 ページ), オーナーズマニュアル (12 ページ), 取扱説明書 (9 ページ)

ページを印刷する

Below are the instructions for installing your DogWatch System. The battery life on the RG1200 & R7

receiver collars = 6 months and on the R1200 & R8 = 2 years. Battery plans can be purchased from

DogFence, either on our web site or direct and a list of approved alternative batteries is listed in your

handbook.

DogWatch systems operate on a digitally encoded FM signal and are safe to use with any electrical or

radio equipment installed on your property.

Tips for Installation

the DVD supplied.

Type of installations: There are many variations on the type of installation that your System can

achieve.

Single Cable – Entire Boundary: The most popular installation is a single boundary cable

around the entire perimeter. This is the most secure system in terms of containment and usually

the easiest type of installation.

Banana Loop – This type of installation is for a rear or front garden only or semi or terraced

property – remember when installing a banana loop the cables must be placed at least 2ft apart

in areas where you require signal. Closing the cable together will deaden or greatly reduce the

signal.

Up and Over installation – this is a 2

you can run the cable up the walls of your house, along the gutter and around the roof or up and

over the roof if you wish to achieve an entire boundary installation without using the banana loop

option. Do take into account though that where the cable runs up the wall you will receive a small

amount of signal internally and this may well affect your dog or cat if it a sleeping area of

passage way that they need to use.

Front or Single Boundary only – similar to the banana loop, we often refer to this installation

as a "there and back system". Again you must keep the cable a min of 2ft apart in areas where

you require signal. Closing the cables together will deaden or greatly reduce the signal.

The table below gives some illustrations.

Remember installing the cable in tubing or burying the cable DOES

SIGNAL.

The only way to deaden the signal is the twist the two cables together.

: Please read and then follow the installation instructions in conjunction with

option for customers with a semi or terraced property –

NOT

REDUCE THE