- ページ 12

コントローラー ASHAPOWER NEON-30のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ASHAPOWER NEON-30 14 ページ。 Solar mppt charge controller
ASHAPOWER NEON-30 にも：ユーザーマニュアル (14 ページ)

ページを印刷する

Note: Before changing the default settings values of the device, ensure the maximum ampere

●

and voltage ratings applicable for your battery type (SMF,LEAD ACID etc) and brand. Blind

settings may cause severe damage to the batteries and charge controller. Default values given

are for lead acid batteries.

ENTERING SETUP MODE:

Setup Mode, connect the settings key to the 9-PIN D-Connector. Press and hold the ENTER button on the key

and switch on the MPPT ON-OFF switch on the device till the charger enters the SETUP MODE on display. All

the indicators and fan start to function. Press the ENTER button to scroll through the setup menu as shown

below. Use the PLUS and MINUS buttons to increase or decrease the default values.

1.CAL-AMP

(AMPS

Calibration

CALIBRATION)

2.CAL-VOL

(VOLT

Calibration

CALIBRATION)

3.BVH-CUT

(BATTERY

CHARGING HIGH

CUT OFF VOLT)

4.MAX-AMP

(CHARGING AMPS)

5.GRD-SOL

(GRID TO SOLAR

CHANGE OVER)

6.SOL-GRD

(SOLAR TO GRID

CHANGE OVER)

7.BLK-LED

(LOW BATTERY

WARNING)

Note: Values will be displayed as multiples of 10 (e.g. 14.5V will be displayed as 145)

SETUPMODE

Switch OFF the device and connect to the desired battery bank. To enter

TYPE

Increase or decrease this value to match the ampere

shown on the display to the reading on your True

RMS DC clamp meter. (FLUKE brand is

recommended)

Measure the terminal voltage of the battery bank

using a DC volt meter and equalise the reading

shown in the display of the charger to your volt meter

reading

Set the battery charging

Settings

high voltage cutoff voltage

Set the maximum charging current cutoff (Max

charging current value is recommended as 20% of

Settings

the Ah of a single 12V C10 Battery connected in

series. e.g. for a 150 Ah C10 Lead Acid battery, 30A

is the recommended charging current)

Set the battery voltage you prefer to shift

Settings

automatically from grid power to inverter (solar

power)

Set the battery voltage you prefer to shift

Settings

automatically from inverter to grid power

Set the low battery level of warning indication LED to

Settings

blink

DESCRIPTION

RANGE

MIN

DEFAULT

MAX

115

220

13V

14.5V

16V

30A

12V

14.0 V

16V

11.0V

16V

11.7V

16V