- ページ 5

計測機器 Akron 3578 STREAMMASTERのPDF 設置、操作、メンテナンスに関する説明書をオンラインで閲覧またはダウンロードできます。Akron 3578 STREAMMASTER 17 ページ。

ページを印刷する

1. Electrical Installation Instructions

C. MONITOR WIRING HARNESS ATTACHMENT

These instructions are to attach the monitor wiring harness to the logic box.

STEP 7

Remove the cable grip nut from the logic box for the wiring harness cable. DO NOT

REMOVE THE CABLE GRIP. Put the cable grip nut on the wiring harness cable with the

threads facing out. Put the cable through the correct logic box cable grip (see component

layout, Figure 5) so the cable grip nut will grab the outer cover of the cable. Tighten the

cable grip nut and attach the individual wires to the proper terminals (see wiring

schematic Figure 6).

D. BATTERY ATTACHMENT

The battery connections should be the last connection made.

STEP 8

AUXILIARY BATTERY - Remove the logic box cable grip nut for the auxiliary battery and

place it on the battery (#16-3) cable with the threads facing out. Thread the cable through

the cable grip nut until the cable grip will grab the cable. Tighten the cable grip and

attach the individual wires to the proper terminals (see wiring schematic Figure 6).

NOTE: Auxiliary Battery is not intended to operate the monitor.

STEP 9

VEHICLE BATTERY - Remove the logic box cable grip nut for the vehicle battery and

place it on the battery cable (#10-2 or #12-2 depending on length) with the threads facing

out. Thread the cable through the cable grip until the cable grip nut will grab the cable.

Tighten the cable grip nut and attach the individual wires to the proper terminals (see wiring

schematic Figure 6). Reattach the logic box cover and secure with the 6 screws.

NOTE: To supply enough current to operate the monitor properly, adequate wire size is critical.

OPERATING INSTRUCTIONS

A. CONTROLLER OPERATION

The controller is used to control the monitor and nozzle.

1. To deploy the monitor for use:

Lift the safety cover on the STOW/DEPLOY switch and push the toggle switch up and release.

Note: Some models may not be equipped with a deploy switch. The Deploy Function will only lower

the monitor. See DIP Switch 3 and 4.

2. To stow the monitor after use:

Lift the safety cover on the STOW/DEPLOY switch and push the toggle switch down and release.

Note: Some models may not be equipped with a deploy switch.

3. To change the horizontal monitor position toward the right or left:

Press the proper toggle switch toward "RIGHT" or "LEFT" respectively, as labeled on the controller,

until the desired position is reached.

4. To change the vertical monitor nozzle position upward or downward:

Press the proper toggle switch toward "RAISE" or "LOWER" respectively, as labeled on the controller,

until the desired position is reached.

5. To change the nozzle pattern toward the straight stream or fog position:

Press the proper toggle switch toward "STRAIGHT" or "FOG" respectively, as labeled on the

controller, until the desired nozzle position is reached.

THE LOWER CONTROL BOX FUNCTIONS WILL OVERRIDE THE UPPER CONTROL BOX

FUNCTIONS IN COMPLIANCE WITH THE REQUIREMENTS OF THE NFPA STANDARD. NOTE: THE

LOWER CONTROL AND UPPER CONTROL WIRES MUST BE ATTACHED TO THE CORRECT

TERMINALS FOR THE LOWER CONTROL (MASTER) TO OVERRIDE THE UPPER CONTROL

(SLAVE). NONE OF THE FUNCTIONS CAN BE CONTROLLED FROM THE UPPER CONTROL BOX

WHEN ANY OF THE SWITCHES ON THE LOWER CONTROL BOX ARE ACTIVATED.

Page 5