- ページ 10

楽器アンプ Ashdown ROOTMASTER RM-500-EVO IIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ashdown ROOTMASTER RM-500-EVO II 16 ページ。

ROOTMASTER EVO II

USER GUIDE

The compression level control adjusts the degree of compression applied

to the bass signal. For this to function correctly the input level must be

correctly set as described in the input control section above. When the

input level is correctly set there will be hardly any difference in volume

between compression in and compression out. This is because the

RM automatically compensates for the reduction in level that would be

apparent when compression is added by increasing the overall gain to

restore the volume to its pre compression level, because of this you may

notice an increase in background noise with high compression settings.

Compression is switched in/out with the push button adjacent to the

compression level control.

Overdrive

This is a valve/tube emulated overdrive that is variable from a slight 'edge'

or 'warmth' through to a fairly aggressive overdrive/distortion effect. The

actual degree of overdrive applied to the bass signal is also dependent

on the setting of the input level control. The higher this is set, the greater

level of overdrive can be applied using the overdrives own rotary control.

Overdrive can be switched in with the push button above and to the

right of the overdrive rotary control. The amount of drive applied to the

overdrive circuit is adjusted using this rotary control. The over-driven bass

signal is applied in parallel with the dry bass signal to ensure you never

lose the full bottom end from your bass. Overdrive is situated after the

compression allowing for a sustained over-driven bass signal to be pro-

duced by adding a degree of compression along with the overdrive itself.