- ページ 2
ウィービング・ツール＆アクセサリー Ashford KNITTERS LOOM STANDのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Ashford KNITTERS LOOM STAND 2 ページ。 30cm (12ins) and 50cm (20ins)
Ashford KNITTERS LOOM STAND にも： 使用方法 (2 ページ)
ページを印刷する
rubber washer
washer & knob
washer & knob
1
Attach the base rail (with the Ashford logo) to one side and one foot and secure with a
washer and knob. Note the metal bracket faces out and the tapered side fits snugly into
the tapered rebate in the foot. Tighten the knobs to make the joint tight.
2
Secure the top rail to the same side with a washer and knob.
3
Attached the other side and foot. Secure with a washer and knob.
4
Completely unthread the side knobs on the Knitters Loom. Remove the steel washers and replace
them with the thin rubber washers. Partially thread the knobs back on. Slide the loom onto
the metal brackets keeping the rubber washers between the loom and the brackets. Tilt the loom
to a convenient weaving angle. Lift the back of the loom to engage the 2 L blocks, check the reed
support blocks are upright and tighten the side knobs.
sides
bottom rail
Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone 64 3 308 9087
[email protected] www.ashford.co.nz
top rail
rubber washer
metal brackets
washer & knob
washer & knob
foot