Ashford KNITTERS LOOM STAND 지침 - 페이지 2

{카테고리_이름} Ashford KNITTERS LOOM STAND에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashford KNITTERS LOOM STAND 2 페이지. 30cm (12ins) and 50cm (20ins)
Ashford KNITTERS LOOM STAND에 대해서도 마찬가지입니다: 지침 (2 페이지)

페이지 인쇄

rubber washer

washer & knob

Attach the base rail (with the Ashford logo) to one side and one foot and secure with a

washer and knob. Note the metal bracket faces out and the tapered side fits snugly into

the tapered rebate in the foot. Tighten the knobs to make the joint tight.

Secure the top rail to the same side with a washer and knob.

Attached the other side and foot. Secure with a washer and knob.

Completely unthread the side knobs on the Knitters Loom. Remove the steel washers and replace

them with the thin rubber washers. Partially thread the knobs back on. Slide the loom onto

the metal brackets keeping the rubber washers between the loom and the brackets. Tilt the loom

to a convenient weaving angle. Lift the back of the loom to engage the 2 L blocks, check the reed

support blocks are upright and tighten the side knobs.

sides

bottom rail

Ashford Handicrafts Limited

415 West Street, Ashburton 7700, New Zealand

Telephone 64 3 308 9087

[email protected] www.ashford.co.nz

top rail

rubber washer

metal brackets

washer & knob

foot