- ページ 4

消防設備 Akron SAM BOOSTのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Akron SAM BOOST 8 ページ。

1. WHAT'S INCLUDED

1.1 Box #1 – SAM BOOST™ Electronic Components

A. Batteries & Battery Chargers

B. Wireless CAN Module & Antenna

C. Matrix Module

D. SAM BOOST™ System Harness

E. Cross Pump Backbone Harness with CAN Hubs

F. SAM BOOST™ Display, Display Labels, Power Module, & Adapter Plate

G. Alarm Buzzer (Optional)

H. Master Intake & Master Discharge Pressure Sensors

I. Caution Labels & Push-Pull Cover Placards

1.2 Box #2 – SAM BOOST™ Valves & Venting Components

a. 2" Preconnect Boost Valves, Pressure Sensors, & Valve Harnesses

b. Tank-to-Pump Boost Valve & Valve Harness

• Customer Specified, 3" or 4" Valve Size Available

c. Pump Venting Solenoid & Fittings

d. Water Tank Level Sensor & Fittings

e. Nozzle Color Handle Kit

2. PREPLAN INSTALLATION

□ Find optimal location for Antenna within 8' of Wire to Wireless CAN Module

□ Lay out all components included in kit on pump as shown in System Layout

□ Verify harnesses are within reach of components

□ Remove Original Valve Components (Controls, drains, etc.)

□ Install Boost Valves

• May require rotating electric actuators for clearance. If valve is rotated then

position sensor calibration (password 08266) must be performed

□ Install Pressure Sensor into Drain Line or Gauge Line near Valve

□ Connect Harnesses to Valve Electric Actuator

• Point Electrical Connection Ports down or sideways to avoid water intrusion

Sheet: FSG-MNL-00233

SAM BOOST™ WITH SMART NOZZLE N

Refer to FSG-MNL-00232 for complete listing of Safety Hazards & Warnings

Revision 7 / 10 / 2023

QUICK START GUIDE

Page: 3 of 7