- ページ 8

レシーバー Cypress CHDBR-2HEのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Cypress CHDBR-2HE 16 ページ。 1 by 2 cat5e/6/7 over hdmi with lan/ir/rs232/bi-directional poe receiver
Cypress CHDBR-2HE にも：操作マニュアル (16 ページ)

ページを印刷する

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Front Panel

HDMI OUT 1/2: Connect each of the HDMI outputs to an HDMI

display for simultaneous HDMI distribution, or cascade the output

to another transmitter to extend the operating distance.

The unit will read the EDID settings of the display device connected

to HDMI OUT 1. If it detects a 4K2K capable EDID setting it will

transmit the signal in that format to all outputs. If no 4K2K capable

EDID is detected then the unit will output the best resolution that all

displays can support.

Note: The unit will retain and use the EDID settings of the last device

connected to the HDMI OUT 1 output if no device is connected to

this output even after switching EDID modes or a power cycle.

LAN: Connect to an active network for LAN serving.

When the transmitter or any compatible LAN equipped transmitters

are connected to a network, this allows the network access

(including internet access if available) to be shared between

the transmitter and connected receiver. Connect any Ethernet

equipped device e.g. a Smart TV or games console to the LAN

port of a receiver for that device to share the network/internet

access.

Warning: DO NOT connect this LAN port to the CAT5e/6/7 port,

doing so may trigger a power shut down and may damage the

device.

RS-232 OUT: Connect to a RS-232 enabled device (with supplied

3.5mm mini-jack to D-sub 9-pin male adaptor) for transmission of

RS-232 commands.

HDMI OUT 1

HDMI OUT 2

Receiver

LAN

RS-232 OUT