Cypress CHDBR-2HE Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Приймач Cypress CHDBR-2HE. Cypress CHDBR-2HE 16 сторінок. 1 by 2 cat5e/6/7 over hdmi with lan/ir/rs232/bi-directional poe receiver
Також для Cypress CHDBR-2HE: Посібник з експлуатації (16 сторінок)
Друкувати сторінку
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
1
HDMI OUT 1/2: Connect each of the HDMI outputs to an HDMI
display for simultaneous HDMI distribution, or cascade the output
to another transmitter to extend the operating distance.
The unit will read the EDID settings of the display device connected
to HDMI OUT 1. If it detects a 4K2K capable EDID setting it will
transmit the signal in that format to all outputs. If no 4K2K capable
EDID is detected then the unit will output the best resolution that all
displays can support.
Note: The unit will retain and use the EDID settings of the last device
connected to the HDMI OUT 1 output if no device is connected to
this output even after switching EDID modes or a power cycle.
2
LAN: Connect to an active network for LAN serving.
When the transmitter or any compatible LAN equipped transmitters
are connected to a network, this allows the network access
(including internet access if available) to be shared between
the transmitter and connected receiver. Connect any Ethernet
equipped device e.g. a Smart TV or games console to the LAN
port of a receiver for that device to share the network/internet
access.
Warning: DO NOT connect this LAN port to the CAT5e/6/7 port,
doing so may trigger a power shut down and may damage the
device.
3
RS-232 OUT: Connect to a RS-232 enabled device (with supplied
3.5mm mini-jack to D-sub 9-pin male adaptor) for transmission of
RS-232 commands.
3
HDMI OUT 1
HDMI OUT 2
1
Receiver
LAN
RS-232 OUT
2
3