- ページ 14

おもちゃ EG Aircraft MX2 50CC Giant Scale Aerobatic AircraftのPDF マニュアルをオンラインで閲覧またはダウンロードできます。EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft 19 ページ。

C OWLING INSTALLATION:

U U

1. Fit the cowling in place and make any cutouts necessary to clear your engine and exhaust components.

Trial fit and trim as necessary being careful and accurate. Be sure to allow enough air exit area in the

bottom of the cowling to provide adequate air flow over the engine. Some modelers may prefer to build

baffling in the front of the cowling to assist air flow over the cylinders. This can be done using scrap

pieces of balsa trimmed to fit your engine installation. Be sure to fuel proof all exposed wood. When

satisfied with the final fit, attach the cowling to the fuselage using the six supplied screws and rubber

washers screwed into the cowl ring. Note the bottom two screws are inserted from the front of the

firewall while the top four are installed from inside the fusealge or back of the firewall.

2. Install the propeller and spinner. Large gasoline engines are very powerful and can cause damage to

persons or property if propellers and spinners are not installed properly. Follow the manufacturer's

instructions and make sure your props are well balanced, properly drilled, and display no cracks or chips.

H ORIZONTAL STABILIZER AND ELEVATOR CONTROLS ASSEMBLY:

U U

1. Install the fiberglass control horns in the same way as you did the rudder horns. Do not cut the

covering on the top side of the elevators but be sure to fully seat the horns into each elevator. You

may need to trim off some of the control horns as shown in the picture below to fully seat the horns in

the elevators. Again, EG recommends you temporarily install the ball link onto the horns while the

glue cures. This will assure proper alignment of each horn.

2. Install your elevator servo into the root of the horizontal stabilizer making sure the servo wire exits

towards the leading edge of the stab.

U U