- ページ 9

おもちゃ EG Aircraft MX2 50CC Giant Scale Aerobatic AircraftのPDF マニュアルをオンラインで閲覧またはダウンロードできます。EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft 19 ページ。

6. Center the tail wheel bracket on the rear of the fuselage and screw in place using three of the supplied

wood screws. Remove the screws and harden the holes with a drop of thin CA. Allow the CA to cure

and then permanently install the tail wheel bracket.

7. Locate the ball link end for the tail wheel wire and drill a small hole a few inches from the rear of the

rudder along the bottom (this may already be done for you). Glue this in place with thick CA or epoxy.

Slide the steering wire through this guide and into the aluminum steering arm. Tighten the set screw

firmly. Test the deflection of the rudder to make sure there is no binding and that the steering wire does

not slide out of the support guide.

R UDDER CONTROL INSTALLATION:

U U