- ページ 5

バッテリーチャージャー EG4 MPPT100-48HVのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。EG4 MPPT100-48HV 10 ページ。 Mppt charger 100a 48vdc

Mount the unit by attaching with two screws. It is recommended to use M4 or M5 screws.

Battery and PV Connections:

NOTE:

This MPPT charger has a built-in battery breaker on the side panel of the unit for added safety,

protection, and to assist with code compliance. (For local codes, check with your local AHJ.)

Ensure the battery breaker is in the off position before installing battery cables.

WARNING! We recommend all wiring be performed under the guidance of a

licensed professional.

WARNING! It is very important for system safety and efficient operation to use

the appropriate cable size for battery connections. To reduce the risk of injury,

please use the recommended cable, stripping length (L2), and tinning length (L1)

in the table below.

Recommended battery cable, stripping length (L2), and tinning length (Ll):

Maximum Battery Wire Size

Model

Amperage capacity AWG/Max

MPPT100-48

100A

Please follow these steps to ensure proper battery connection:

1. Remove insulation sleeve 18 mm (0.7") for positive and negative cables based on recommended stripping

length.

2. Connect all the batteries to the system. Insert the battery cable into the battery connector of the charger

and make sure the bolts are tightened with a torque of 2-3 Nm.

3. Make sure the polarity at both the battery and the charger is correct. Verify that the battery cables are

torqued to the proper value of the battery terminals to avoid loose connections.

Recommended

100AH 3AWG/2AWG 6'/l.8m up to 15'/4.6m

{mm/in.) {mm/in.)

Wire Lenqth

3/0.1"

Stripping Length:

L 2

Torque

value

2~ 3 Nm

18/0.7"