- ページ 7

食器洗い機 Asko D1976CSTMのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Asko D1976CSTM 14 ページ。 Standard dishwashers
Asko D1976CSTM にも：取扱説明書 (12 ページ), クイック・スタート・マニュアル (2 ページ), インストールとカスタマイズ (4 ページ), 取扱説明書 (12 ページ)

ページを印刷する

REMOVING THE TOE KICK BRACKETS

To remove the toe kick brackets, hold the small metal

spring tab on the outer edge of the base pan toward the

outside of the machine. Continue holding the tab as

you pull straight out on the bracket. (Note: It may be

stubborn because it's in guide slots on the base pan.)

See page 10 for instructions on how to adjust the toe

kick brackets.

REMOVING THE GUARD PLATE

If the cord is not long enough, or if a hard-wire

installation is needed, you will need to remove the guard

plate to complete the electrical connection.There are

four 20 torx or flathead screws that hold the guard plate

in place, two on the upper/underneath side and two on

the front.

Guard plate

To remove the guard plate, first remove the toe kick

brackets (see this page). Then remove the two screws

on the upper/underneath side of the guard plate. Next,

remove the two screws from the front side of the guard

plate.

MOVING THE MACHINE INTO PLACE

WARNING!

Make sure you put the protective slides on the rear

legs to prevent damaging the floor when you slide the

unit into place (see page 6).

Position the machine in front of the cabinet

opening.

Make the height adjustment while the dishwasher

is in front of the opening.

Pull out the drain hose to ensure there are no sharp

bends.

On the bottom rear of the dishwasher there is a

black ziptie around the rubber buffer that holds the

circulation pump in place. Cut the ziptie and remove it.

Start to feed water and drain lines and electric cord

(if necessary) into the access hole in the cabinet.

Gently slide the unit into the dishwasher opening.

As you do this, feed the drain line into the drain line

and inlet hose into the access hole in the side of

the cabinet.

Remove the two

screws on each

side of the guard

plate.

Toe kick bracket

After the screws are removed, grip the bottom of the

guard plate and pull it toward you to remove it. You can

now access the inlet valve, electrical connection, and

drain pump and hose, as illustrated below.

As you slide the unit into place, feed the drain line and

inlet hose into the access hole in the side of the cabinet.

WARNING! Be careful of sharp edges.

Page 7