- ページ 14
ツール Bluerock Tools PTK-300のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Bluerock Tools PTK-300 20 ページ。 Pipe threading kit for pd- 300/ptm-300
ページを印刷するP T K - 3 0 0
P I P E
T H R E A D I N G
Troubleshooting
SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.
DON'T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!
PROBLEM
Threading machine unplugged
Motor does not
Fuse blown
start (IF USING
OPTIONAL PD-
Capacitor blown
300)
Bad on/off switch
Cutting blade is dull
The cutting knife
Lead screw on cutting blade assembly is
will not cut
damaged
Too much force being applied
Motor sounds
Overload because of dull dies
Overloaded (IF
USING
Bad quality or insufficient thread cutting oil
OPTIONAL PD-
300)
Sparks coming
Bad contact between brushes and brush
holder
from motor (IF
USING
Brushes do not touch armature properly
OPTIONAL PD-
Sharp edge on brush
300)
Die head does
Dull or broken dies
not start
Improperly set dies
threading
Dull dies
Dies not assembled in correct sequence
Damaged
Thread
Low quality pipe
Bad quality or insufficient thread cutting oil
Chuck jaws are not tightening enough
3-jaw chuck not tight
Pipe turns while
3-jaw chuck teeth dirty
threading
3 jaw chuck teeth damaged or dull
K I T
Note
CAUSE
11
CORRECTION
Plug into power source
Replace the fuse
Replace capacitor
Replace Switch
Replace blade
Replace assembly
Cut slower
Replace dies
Use thread cutting oil in adequate quantity
Tighten the screws, make sure brush is pressed
firmly onto armature
Replace worn brushes
Break edge with sand paper
Replace dies
Reset dies
Replace dies
Put dies in correct sequence
Make sure only pipe of good quality is used
Use only thread cutting oil in adequate quantity
Inspect chuck jaws
Tighten handwheel chuck
Clean with wire brush
Replace 3-jaw chuck
4
Chapter