- ページ 4

食器洗い機 Asko DOD651PHXXLSのPDF 操作説明をオンラインで閲覧またはダウンロードできます。Asko DOD651PHXXLS 5 ページ。
Asko DOD651PHXXLS にも：操作説明 (2 ページ), 設計マニュアル (20 ページ)

Placing the dishwasher

The dishwasher is intended for freestanding installation, but can also

be installed under a countertop.

Use caution when the appliance is installed or removed to reduce the

likelihood of damage to the power supply cord.

Adjust the height and slide the

dishwasher into place

Freestanding

1 Make sure the area where the dishwasher will be installed is firm.

Adjust the dishwasher's height using the four adjustable feet to level

the unit. The dishwasher may lean no more than 0.2" (5 mm).

2 Lock the steel feet with the lock nuts.

3 Once the feet are properly adjusted, tighten the anti-tip feet firmly

against the floor.

Anti-tip feet

Built-in

1 Start by measuring the height from the floor to the bottom edge of

the countertop.

2 Measure the height from the floor to the top edge of the dishwasher.

3 Adjust the dishwasher's feet by turning them clockwise to raise or

counterclockwise to lower the machine.

4 Verify there is an air gap of at least 1/8'' between the underside of

the countertop and the top edge of the dishwasher.

5 Tighten the lock nuts (lock nut) on the rear feet.

6 Slide the dishwasher into place.

• Pull the drain and supply hoses through the opening as the

dishwasher is slid into place.

• Check that the hoses have no kinks or sharp bends, and check

that there is nothing that can damage the hoses.

7 Make any final adjustments to the front feet (the dishwasher may

lean no more than 1/4'') and tighten the lock nuts.

8 Once the feet are properly adjusted, tighten the anti-tip feet firmly

against the floor.

5/8''

1''