Asko DOD651PHXXLS 운영 지침 - 페이지 4
{카테고리_이름} Asko DOD651PHXXLS에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko DOD651PHXXLS 5 페이지.
Asko DOD651PHXXLS에 대해서도 마찬가지입니다: 운영 지침 (2 페이지), 디자인 매뉴얼 (20 페이지)
페이지 인쇄
Placing the dishwasher
The dishwasher is intended for freestanding installation, but can also
be installed under a countertop.
Use caution when the appliance is installed or removed to reduce the
likelihood of damage to the power supply cord.
Adjust the height and slide the
dishwasher into place
Freestanding
1 Make sure the area where the dishwasher will be installed is firm.
Adjust the dishwasher's height using the four adjustable feet to level
the unit. The dishwasher may lean no more than 0.2" (5 mm).
2 Lock the steel feet with the lock nuts.
3 Once the feet are properly adjusted, tighten the anti-tip feet firmly
against the floor.
Anti-tip feet
Built-in
1 Start by measuring the height from the floor to the bottom edge of
the countertop.
2 Measure the height from the floor to the top edge of the dishwasher.
3 Adjust the dishwasher's feet by turning them clockwise to raise or
counterclockwise to lower the machine.
4 Verify there is an air gap of at least 1/8'' between the underside of
the countertop and the top edge of the dishwasher.
5 Tighten the lock nuts (lock nut) on the rear feet.
6 Slide the dishwasher into place.
• Pull the drain and supply hoses through the opening as the
dishwasher is slid into place.
• Check that the hoses have no kinks or sharp bends, and check
that there is nothing that can damage the hoses.
7 Make any final adjustments to the front feet (the dishwasher may
lean no more than 1/4'') and tighten the lock nuts.
8 Once the feet are properly adjusted, tighten the anti-tip feet firmly
against the floor.
5/8''
1''
21