- ページ 8

ドライヤー Asko DOMESTIC TD85のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Asko DOMESTIC TD85 16 ページ。 Heat pump tumble dryer
Asko DOMESTIC TD85 にも：取付説明書 (12 ページ)

BUILT-IN

8-3/4"

222 mm

ASKO dryers can be installed beneath a cabinet

or worktop with a minimum height of 34" (864 mm).

There must be a gap of about 1/2" (12 mm) all

around the machine, including between the rear

edge of the machine and the back wall. The opening

width must be at least 24-1/2" (622 mm).

The height adjustment for the dryer is 33-1/2" to

34-1/2" (850 mm to 876 mm). Do not raise it higher

than 34-1/2" (876 mm). Hole measurements are from

center of hole.

4-1/2"

115 mm

Customer Care Center, 1-800-898-1879, www.askona.com

Closet Install- Ventilation Requirements

ASKO's front panel controls make it possible to

install the washers and dryers in a closet. Make sure

there is clearance between units and cabinet or wall

and a 1" (25 mm) minimum clearance between the

rear edge of the machine top panel and the cabinet

or wall. To ensure proper ventilation, we recommend

louvered doors. Otherwise there must be ventilation

openings in the door. See illustration for minimum

ventilation openings below (gray boxes):

Ensure the dryer door can be opened without

hindrance after installation.

The cool air intake panel at the front of the dryer

must not be blocked or covered. Doing so could

cause an error.