Asko DOMESTIC TD85 Handleiding voor installatie-instructies - Pagina 8
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Asko DOMESTIC TD85. Asko DOMESTIC TD85 16 pagina's. Heat pump tumble dryer
Ook voor Asko DOMESTIC TD85: Handleiding voor installatie-instructies (12 pagina's)
Pagina afdrukken
BUILT-IN
8-3/4"
222 mm
ASKO dryers can be installed beneath a cabinet
or worktop with a minimum height of 34" (864 mm).
There must be a gap of about 1/2" (12 mm) all
around the machine, including between the rear
edge of the machine and the back wall. The opening
width must be at least 24-1/2" (622 mm).
The height adjustment for the dryer is 33-1/2" to
34-1/2" (850 mm to 876 mm). Do not raise it higher
than 34-1/2" (876 mm). Hole measurements are from
center of hole.
8
4-1/2"
115 mm
Customer Care Center, 1-800-898-1879, www.askona.com
Closet Install- Ventilation Requirements
ASKO's front panel controls make it possible to
install the washers and dryers in a closet. Make sure
there is clearance between units and cabinet or wall
and a 1" (25 mm) minimum clearance between the
rear edge of the machine top panel and the cabinet
or wall. To ensure proper ventilation, we recommend
louvered doors. Otherwise there must be ventilation
openings in the door. See illustration for minimum
ventilation openings below (gray boxes):
Ensure the dryer door can be opened without
hindrance after installation.
The cool air intake panel at the front of the dryer
must not be blocked or covered. Doing so could
cause an error.