- ページ 7

ドライヤー Asko TD75のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Asko TD75 13 ページ。 Condenser tumble dryer
Asko TD75 にも：取付説明書および取扱説明書 (12 ページ)

BUILT-IN

ASKO dryers can be installed beneath a cabinet

or worktop with a minimum height of 34" (864mm).

There must be a gap of about 1/2" (12mm) all around

the machine, including between the rear edge of the

machine and the back wall. The opening width must

be at least 24-1/2" (622 mm).

The height adjustment for the dryer is 33-1/2" to

34-1/2" (850 mm to 876 mm). Do not raise it higher

than 34-1/2" (876 mm). Hole measurements are from

center of hole.

Customer Care Center, 1-800-898-1879, www.askousa.com

Install in a closet

ASKO's front panel controls make it possible to

install the washers and dryers in a closet. Make

sure there is a ½" (12mm) minimum clearance

between units and cabinet or wall. To ensure

proper ventilation, we recommend louvered doors.

Otherwise there must be ventilation openings in

the door. See illustration for minimum ventilation

openings:

Ensure the dryer door can be opened without

hindrance after installation.

The cool air intake panel at the front of the dryer

must not be blocked or covered. Doing so could

cause a fault.