- ページ 8

ドライヤー Asko TD75のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Asko TD75 13 ページ。 Condenser tumble dryer
Asko TD75 にも：取付説明書および取扱説明書 (12 ページ)

ページを印刷する

AIR EXHAUST

The tumble dryer must only be operated when it

is correctly ﬁ tted with exhaust duct.

Connecting the exhaust duct to the dryer

You will need to purchase a UL-CSA-approved

4" ridged metal exhaust duct. The dryer is delivered

with the stub pipe attached to the rear exhaust

outlet, though the exhaust duct can be attached to

either the left or the right exhaust outlet.

Asko dryers have a "T-style" exhaust

vent that allows you to connect the duct

on the rear, on the left, or on the right

side

Side Exhaust

Outlet

The duct must not be assembled with screws or

other fasteners that extend into the duct and catch

lint.

To connect the exhaust duct to the rear outlet

To connect the exhaust duct to the rear outlet, follow

the steps below:

1. Push the duct onto the stub pipe and secure it

with a clamp

2. With the duct attached, insert the stub pipe into

the hole. It should snap into place.

3. After you push the dryer into place, check for

kinks in the duct.

Excessive duct length and too many bends can

impede drying performance. We recommend that

you cut oﬀ any excess exhaust duct and run the duct

with as few bends as possible. Make any necessary

bends as gentle as possible.

Maximum duct length of 60 feet. A maximum

of 4 elbows may be used, but 4 feet of duct must

subtracted from the total vent length for every 90°

elbow used.

Vent

T-tube

Rear Exhaust

Outlet

Stub

Duct

Clamp

(not supplied)

Customer Care Center, 1-800-898-1879, www.askousa.com

Connecting the exhaust duct to the Left or Right

Side Outlet

To connect the exhaust duct to the left or right side

outlet, follow the steps below:

1. Using a ﬂ athead screw-driver, turn the exhaust

outlet cover you plan to use to the right or left to

align the tabs holding the cover in place.

2. Remove the exhaust outlet cover.

3. Remove the stub pipe from the rear exhaust outlet

and place it in the outlet you plan to use.

4. Push the duct (3) onto the stub pipe (1) and

secure it with a clamp (2).

5. With the duct attached, insert the stub pipe into

the hole. It should snap into place.

6. After you push the dryer into place, check for

kinks in the duct.

7. Use the exhaust outlet cover you removed from

the to cover the rear exhaust outlet.

2 3