- ページ 10

ドライヤー Asko TD75のPDF 取付説明書および取扱説明書をオンラインで閲覧またはダウンロードできます。Asko TD75 12 ページ。 Condenser tumble dryer
Asko TD75 にも：取付説明書 (13 ページ)

ページを印刷する

1. Installation

1. Turn the power oﬀ at the breaker or fuse box.

2. Remove terminal block cover.

3. Use the strain relief attached below the terminal

block opening.

4. Loosen or remove center terminal block screw.

5. Connect ground (center) wire of power supply

cord to the center, silver-colored terminal screw.

Tighten screw.

6. Connect the other wires to outer screws.

7. Tighten the strain relief screws.

8. Replace terminal box cover on back of dryer.

9. Plug dryer into wall receptacle.

10.Turn power on at breaker/fuse box.

Connecting a 4-wire Power Cord

Before starting this procedure, be sure the

power is turned oﬀ at the breaker/fuse box.

4-Wire Cord

Neutral

Ground

prong

Spade terminals with

upturned ends

3/4" UL-listed

Ring

strain relief

terminals

Neutral

(White)

Ground

(green)

Customer Care Center, 1-800-898-1879, www.askousa.com

Power Supply Cord

You will need a 4-wire power supply cord with

four No. 10 copper wires and a matching 4-wire

receptacle of NEMA Type 14-30R, as illustrated

below. The fourth wire must be identiﬁ ed with a white

cover and the ground conductor by a green cover.

To connect a 4-wire power cord to the dryer, follow

the steps below.

The numbers in the illustration correlate to the

step numbers.

1. Turn the power oﬀ at the breaker/fuse box.

2. Remove terminal block cover.

3. Use the strain relief attached below the terminal

block opening.

4. Remove center terminal block screw.

5. Remove ground wire (green with yellow stripes)

from external ground connector screw and

remove from center terminal block.

6. Connect ground (green) wire of cord to external

ground conductor screw.

7. Connect neutral (white) wire of cord under center

screw of terminal block.

8. Connect the other wires to outer screws.

9. Tighten the strain relief screws.

10.Replace terminal box cover on back of dryer.

11.Plug dryer into wall receptacle.

12.Turn power on at breaker/fuse box.