- ページ 2
タイマー Ambient NanoLockitのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Ambient NanoLockit 2 ページ。 Timecode + logging
Ambient NanoLockit にも： クイック・スタート・マニュアル (2 ページ), クイック・スタートアップ・マニュアル (20 ページ), クイック・スタート・マニュアル (5 ページ), マニュアル (4 ページ), チュートリアル (5 ページ), クイックマニュアル (2 ページ), マニュアル (19 ページ)
ページを印刷する
4A
Sync your devices
Option A
Device with timecode inter-
face: connect NanoLockit to
TC Input.
NOTE: Adjust the device menu settings to
accept external timecode. Please check the
manufacturer's manual.
4B
Sync your devices
Option B
DSLR & cameras wi-
thout timecode interfa-
ce: connect NanoLockit
with audio input and
set audio level. TC sig-
nal will be written on
audio track.
Learn more about the NanoLockit and watch helpful
tutorials at
nanolockit.com
and ambient.de/en/university.
www.nanolockit.com/guide
Setting the TC audio level
Track levels must be set
correctly:
TC
1. Manually set the camera
FPS
audio input level to 50% of
the range.
2. Adjust the NanoLockit TC
output level so the meter
falls between –30 dB to
–20 dB.
TC IN
Hold Green Button
and repeatedly
press Red Button
to reduce
level.
TC
T
K I
C
O
L
O
N
A
N
5
Final setup
Congratulations!
All your devices are
now in perfect time-
code sync.
Sound recording
Sound rec.
Manual
Rec. level
NANOLOCKIT
Wind filter
Disable
– dB 40
L
R
Hold Red Button
and repeatedly
press Green
Button to
increase level.
tap
hold
tap
TC 01:23:45:12
25 fps
TC IN
NANOLOCKIT
TC OUT
NANOLOCKIT
Audio Recorder
DSLR Camera
Switch off
To power down a NanoLockit, press and
hold the Power Button for 5 seconds.
0
NOTE: Power down your NanoLockit manually after
charging/supplying with external power to avoid battery
drain when not in use.
SPECIAL
TRX Mode
For sending a prerecorded timecode to
slates or remotely start/stop recorders
via external record run timecode.
To use your NanoLockits in this special
mode start them by holding the Red
Button while "confirming" with a
single tap on the Power Button.
hold
The units will switch to ACN
channel 11 and blink in TRX
idle mode
.
Timecode from an external source can now be sent from one de-
vice to other devices. This external source must be permanently
connected to this NanoLockit via
TC input or MIDI USB.
The NanoLockits will
now automatically
start and stop their
generators along
with the source.
NANOLOCKIT
NOTE: Source timecode and Lockits are not synchronized, this may lead to drift between source and
Film Camera
receivers on long takes. Do not use for standard sync situations.
5 sec
hold
3 sec
tap
REC
TC
TC IN
NANOLOCKIT
TC OUT
NANOLOCKIT
NANOLOCKIT
Audio Recorder
DSLR Camera
Film Camera