ACR Electronics FPR-20 PROGRAMMER 제품 지원 매뉴얼 - 페이지 4

{카테고리_이름} ACR Electronics FPR-20 PROGRAMMER에 대한 제품 지원 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics FPR-20 PROGRAMMER 15 페이지. Field programmer reader

페이지 인쇄

406 GPS I (P/N 2797.2, 2798.2, 2799.2) self tested components: Data Integrity and

Memory; 406 MHz Synthesizer; RF Power/Battery

406 GPS I/O (P/N 2797.4, 2798.4, 2799.4) self tested components: Data Integrity and

Memory; 406 MHz Synthesizer; RF Power/Battery; GPS header

If your beacon flashes two green LED's, the test has been successfully completed. If you

encounter only the initial green LED flash alone, your beacon has failed the self test,

please contact ACR Electronics or an authorized Battery Replacement Center for

servicing of your beacon.

NOTE: During a self test your beacon will send a 406 MHz signal coded as self-test to

the satellite system. The homing signal at 121.5 MHz is inhibited during self test; this

allows you to test your beacon any time during the day without causing any false alarms.

SECTION 3 – BEFORE YOU RUN SETUP

Before you run the FPR-20 installation software, please make sure that your computer

meets the minimum requirements in section 3.2.

3.1

FPR-20 Components

See Figure 7 for a visual representation of each component listed below.

• Programming Head, BEACON

• Adapter Jack Assembly

• 6 Conductor Cable with RJ11 plug (phone)

• Programming Plug Adapter

• Installation Disk/CD

3.2

Check the Hardware and System Requirements

To run the FPR-20, you must have certain hardware and software installed on your

computer. The requirements include:

• Microsoft Windows 95 / 98 /, NT4.0, 2000, ME or XP.

• Pentium 75 MHz microprocessor (minimum).

• A hard disk with at least 10 megabytes of available storage.

• VGA or higher-resolution screen supported by Microsoft Windows.

• 16 megabytes of RAM.

• A mouse or other pointing device.

A3-06-2413

A3-06-2391

A2-07-0137

A1-18-1970

K3-06-0009

Y1-03-0181 Rev. A