ACR Electronics FPR-20 PROGRAMMER Manual de apoio ao produto - Página 4
Procurar online ou descarregar pdf Manual de apoio ao produto para Acessórios ACR Electronics FPR-20 PROGRAMMER. ACR Electronics FPR-20 PROGRAMMER 15 páginas. Field programmer reader
Imprimir página406 GPS I (P/N 2797.2, 2798.2, 2799.2) self tested components: Data Integrity and
Memory; 406 MHz Synthesizer; RF Power/Battery
406 GPS I/O (P/N 2797.4, 2798.4, 2799.4) self tested components: Data Integrity and
Memory; 406 MHz Synthesizer; RF Power/Battery; GPS header
If your beacon flashes two green LED's, the test has been successfully completed. If you
encounter only the initial green LED flash alone, your beacon has failed the self test,
please contact ACR Electronics or an authorized Battery Replacement Center for
servicing of your beacon.
NOTE: During a self test your beacon will send a 406 MHz signal coded as self-test to
the satellite system. The homing signal at 121.5 MHz is inhibited during self test; this
allows you to test your beacon any time during the day without causing any false alarms.
SECTION 3 – BEFORE YOU RUN SETUP
Before you run the FPR-20 installation software, please make sure that your computer
meets the minimum requirements in section 3.2.
3.1
FPR-20 Components
See Figure 7 for a visual representation of each component listed below.
• Programming Head, BEACON
• Adapter Jack Assembly
• 6 Conductor Cable with RJ11 plug (phone)
• Programming Plug Adapter
• Installation Disk/CD
3.2
Check the Hardware and System Requirements
To run the FPR-20, you must have certain hardware and software installed on your
computer. The requirements include:
• Microsoft Windows 95 / 98 /, NT4.0, 2000, ME or XP.
• Pentium 75 MHz microprocessor (minimum).
• A hard disk with at least 10 megabytes of available storage.
• VGA or higher-resolution screen supported by Microsoft Windows.
• 16 megabytes of RAM.
• A mouse or other pointing device.
A3-06-2413
A3-06-2391
A2-07-0137
A1-18-1970
K3-06-0009
3
Y1-03-0181 Rev. A