FLO-DYNAMICS TSD440 매뉴얼 - 페이지 13

{카테고리_이름} FLO-DYNAMICS TSD440에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FLO-DYNAMICS TSD440 20 페이지. Transmission fluid dipstick x-changer
FLO-DYNAMICS TSD440에 대해서도 마찬가지입니다: 빠른 시작 지침 (3 페이지)

페이지 인쇄

Flo-Dynamics

TSD440™

3.01 BASIC OPERATING INSTRUCTIONS

IMPORTANT

Turn vehicle's A/C system OFF before starting an exchange.

New transmission fluid MUST be 65°F or above for optimal performance.

FIRST TIME OPERATION (Priming the System)

(Only necessary when machine is received, before first operation.)

System must be primed before first use.

1. Connect machine to battery

2. Make sure fluid is in new fluid tank

3. Connect the red service hose to the fitting on the left side of the machine

4. Press 0

5. Press 5

6. Press START

Prime Fitting

TRANSMISSION FLUID EXCHANGE

1. Connect battery leads.

2. Press 2 to select "Dipstick Exchange".

3. Connect red & grey service hoses to chrome manifold.

4. Insert nylon tube down ATF dipstick tube, being cautious not to insert too far.

5. With engine off, select quantity using the ▲ and ▼ buttons, and press START.

6. To skip cleaning process, press "1" and continue to step 10.

Cleaning Process (Optional)

7. Press "2" for 5 Minute Cleaning, or "3" for 10 Minute Cleaning.

When adding chemicals, add directly to the vehicle for best results.

8. Press "START" to begin cleaning process.

9. When cleaning process is complete, shut off engine.

10. Follow instructions on screen and press START. Exchange will begin. Once the exchange

has begun, press the STOP button once to pause the machine. Press START to resume

from pause. Press STOP a second time to cancel the exchange.

11. After first cycle completes, start vehicle's engine and press START.

12. After second cycle completes, the unit will beep and display "Complete".

13. You may top off or remove fluid by using the "ADD FLUID" or "REMOVE FLUID" buttons.

14. Press 0 to return to the main menu.

Operations Manual

Printed in the U.S.A. for Flo-Dynamics ®

III. Operating Procedures