ACR Heat Products The Astwood AW1MF 기술 매뉴얼 - 페이지 3

{카테고리_이름} ACR Heat Products The Astwood AW1MF에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Heat Products The Astwood AW1MF 13 페이지. Multifuel stove

ASTWOOD SPECIFICATIONS

Nominal heat output ............ 7 kW – WOOD 6.8 kW – SMOKELESS FUEL

Chimney draft required ......... 12Pa

Height ................................. 595 mm

Width .................................. 545 mm

Depth .................................. 415 mm

Weight ................................. 80 kg

Direct Air Intake..................... 80mm

Air Requirement .................... 11cm/sq

Flue Mass Gas Flow ............... g/s – WOOD

g/s – SMOKELESS FUEL

Mean Flue Gas Temperature .. °C – WOOD

°C - SMOKELESS FUEL

Efficiency .............................. %

Log Length ............................ 400 mm

*** Please note that Building Regulations Document J advises that

additional air supply is required for appliances with an output of above

5Kw.

With modern properties additional air may be required as

Document J suggests that adequate air would be a benefit. If in doubt,

please consult your registered installer for advice. NOTE: Extractor fans

when operating in the same room or space as the appliance may cause

problems.

Location of the unit

Clearances to non-combustible materials

There must be a minimum clearance of 150mm at each side of the

appliance. A clearance of 150mm is required at the back of stove (if the

rear wall has a thickness of 200mm or more this measurement can be

reduced to 50mm) A minimum clearance of 150mm is required above the

appliance.

Clearances to combustible materials

There must be a minimum clearance of 450mm at each side and 750mm

at the rear of the appliance from any combustible materials. If using

single wall flue pipe, there must be a clearance of at least 3 times the

diameter of the flue pipe (e.g 125mm diameter pipe = 375mm minimum

clearance) from any combustible materials e.g wooden beam.

Curtains and soft furnishings should be a minimum of 1m away from the

appliance.

Adequate space should be provided for servicing the appliance.