ACR Heat Products The Astwood AW1MF 기술 매뉴얼 - 페이지 4

{카테고리_이름} ACR Heat Products The Astwood AW1MF에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Heat Products The Astwood AW1MF 13 페이지. Multifuel stove

We do not recommend that plasma televisions and expensive artwork are

hung over the fireplace.

Please remember that this appliance has been designed to provide heat

and if installed into a recess enough space should be left around the

appliance to enable the heat produced to rise and escape from the

recess back into the room.

Hearth Requirements

The appliance must stand on a level fireproof hearth with a minimum

thickness of 12mm. The hearth temperature created by this stove is below

100˚C. The hearth must protrude at least 300mm in front of the appliance

and 150mm either side of the appliance.

The appliance shall be installed on a floor with an adequate load bearing

capacity.

If an existing construction doesn't meet with prerequisite,

suitable measures (e.g. load distributing plate) shall be taken to achieve it.

Flue Requirements

The chimney must comply with current Building Regulations.

Provision

must be made to provide access for cleaning the appliance, the flue gas

connector and the chimney flue.

The flue must be:

• In sound condition and provide sufficient draft

• Suitable for use with solid fuel burning appliances

• Free from deposits

• Well insulated

• At least 4.5m in height

The flue must not be:

• Shared with other appliances

• Weight bearing on the appliance

• A smaller diameter than the appliance flue collar size (125mm)