AMCON EQ-6002 사용자 설명서 - 페이지 10

{카테고리_이름} AMCON EQ-6002에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMCON EQ-6002 12 페이지. Automatic chart projector

Automatic Chart Projector - EQ-6002

________________________________________________________________

6. Maintenance and Care

• Cover the projector when not in use. This instrument is sensitive to dust

contamination.

• Turn the power switch off when not in use. It is also recommended to

unplug this instrument when not in use for longer periods of time.

• Keep projector clean by wiping the outside panels with a dry cloth. To

remove more difficult stains, a damp cloth with a mild detergent may be

used. A mild glass cleaner may be used on the outside panels. Be

careful not to dampen the inside parts of the projector.

When the lens is dirty, wipe it lightly with a good quality, dry microfiber

•

cloth. An Amcon Vista Cham is recommended.

Caution: To avoid electric shock, unplug the power cable when replacing the

projection lamp.

Caution: Do not replace the projection lamp immediately after turning off the

light. The lamp may still be hot and could lead to burns.

Turn the power switch off. Remove the lamp cover screw and remove the cover.

Remove the lamp attaching screw, hold the socket and remove the lamp. Hold

the socket and the lamp flange and remove the lamp from the socket. Install the

new lamp securely. Make sure you install it in the correct direction. Do not touch

the glass of the bulb directly with your fingers. If the bulb is touched by accident,

wipe the fingerprint off with alcohol. Replacement bulbs are available from

Amcon Product number: RQ-6200. Match the protruded part of the lamp

attaching area with the lamp flange notch and tighten with the lamp attaching

screw to secure the lamp. Place the lamp cover on. Turn the power switch on.

Make a trial projection to check that there is no illumination irregularity. If there is

any irregularity, turn the power off again and check that the lamp is properly

installed.

Warning: Unplug the power cable before removing the fuse cover to replace the

fuse. Removing the fuse cover with the power cable plugged in can cause

electric shock.

Warning: Use only attaching fuses (250 v, 1A). Using other fuses may cause a

fire in the event that the instrument fails.