AMCON EQ-6002 사용자 설명서 - 페이지 9

{카테고리_이름} AMCON EQ-6002에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMCON EQ-6002 12 페이지. Automatic chart projector

Automatic Chart Projector - EQ-6002

________________________________________________________________

5.3 Using the Program Function

Accessing the Programming Mode

a) Turn on the power switch. The projector goes into initialization state.

b) Press the "RESET" button on the remote control.

c) Press the "R and G filter" button on the remote control.

d) Press the "Reset" button again on the remote control. The projector

will beep twice after pressing each button in "1b, 1c, 1d". After the

third button, the projector will be in programming mode. At any time

up to step "d", pressing any other button will return the projector to

normal operating state.

Select Program 1 or 2

Press the "P1/P2" switch to select program 1 or 2. The beeper will sound

once if program 1 is selected and twice if program 2 is selected.

Selecting Charts for the Program

a) Press the "program up" button to open the position for the first chart.

b) Select the desired chart button along with the desired "highlight"

button.

c) Press the "program up" button again to enter the selection and move

to open the next position of the program. The beeper will sound four

times. Repeat steps 3a, 3b, 3c to enter other charts. Up to 30

selections are possible.

Completing the Program

a) When finished entering, press the "Reset" button to exit.

b) Press the light switch to turn off the projector.

Using the Program

a) To use a program, select program P1 or P2 by pressing the "P1/P2"

button. The beeper will indicate the program selected by sounding

once for P1 and twice for P2.

b) Press the "Program Up" button to run the program. The "Program Up"

and "Program Down" buttons will advance or reverse the program.