ACR Heat Products NI22 설치 및 사용 설명서 - 페이지 6

{카테고리_이름} ACR Heat Products NI22에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Heat Products NI22 9 페이지.

6. Place the canopy on the stove resting the base of the canopy on the

right angle brackets. Ensure there is a minimum 15mm gap between the

rear wall of the fireplace and the rear of the canopy to allow the hot air to

circulate.

When satisfied with the position of the canopy, attach each right angle

bracket into the canopy base and secure with the supplied nut & bolt.

7. Attach the base cover to the front of the appliance by sliding the cover

into the gap provided by the leg bolts.

SOME FACTS ABOUT YOUR STOVE

This appliance is fitted with air controls which should be operated as

follows:-

PRIMARY AIRSLIDE

(Located to the right hand side below the doors)

Pushed in = CLOSED

Pulled out = OPEN

SECONDARY AIRSLIDE

(Located to the right hand side above the doors)

Lever to the left = CLOSED

Lever to the right = OPEN

To open the door, point the door handle up. To close the door, point the

door handle horizontally.

The inside of the stove is lined with vermiculite panels. These will break

under strong impact. Therefore, please ensure that when reloading your

stove, logs are placed onto the stove base rather than thrown to avoid

any breakages. The vermiculite panels are a "wear and tear" component

and are not covered by warranty.

FIRST FIRING OF APPLIANCE

During the first firing of your stove, the high temperature paint will cure.

This process will give off some smoke for a couple of hours depending on

the temperature of the fire.

This is perfectly normal but we do