Amcor NanoMax Series 설정 지침 - 페이지 2

{카테고리_이름} Amcor NanoMax Series에 대한 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Amcor NanoMax Series 2 페이지. Nanomax portable air conditioner with innovative autodrain nanomist technology
Amcor NanoMax Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Continued from Reverse Side

3. Installation of the Window Kit

1. Place Adjustable Slide Bar (D) in the window and expand

so it fits tightly.

2. Mark Slide Bar to record width of the window.

3. Apply Insulation Strip (E) on top and bottom of Slide Bar.

4. Reposition Slide Bar Connector in the window.

Expand the Slide Bar to fit tight. Tighten the screws.

5. Lower the window.

6. Make sure Hose has no kinks.

4. Turning the Unit On

1. Plug the unit into a working electrical outlet.

2. Press the unit's ON/OFF Button on the control panel.

It may take a few minutes before cold air is dispersed.

3. If unit doesn't turn on, press top Reset Button on plug, shown

at right, and plug back in outlet. Green light should be on.

4. Adjust FAN Speed by pressing the FAN Button until

the preferred fan speed is reached.

5. Press the Timer Button to Set.

Assemble the

hot air hose on

the unit.

Unfold flexible

hose with

attached hose

adapter

connector,

and snap into

Window

Slide Bar.

Green Light

Clip on the

water atomizer

at the end of

the spiral pipe

to the holder.

Only

Required For

Dissassembly.

In order to

unlock the quick

connector, push

the tab and turn

the connector

90 degrees

counter-clockwise.

Adjustable

Slide Bar

Connector

Hose

Reset Button

RESET

TEST