Amcrest ATC-801 사용자 설명서 - 페이지 6

{카테고리_이름} Amcrest ATC-801에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amcrest ATC-801 15 페이지. Digital game & trail hunting camera

To supply power to the camera, four or eight AA size batteries are needed.

Open the bottom cover. Confirm that the power switch is in the OFF (right) position,

pull out the battery holder. Load the fully charged batteries into the holder according to

the polarity shown below. Push the battery holder back into the battery chamber.

The following batteries with 1.5V output can be used:

1. High-density and high-performance alkaline batteries (Recommended)

2. Rechargeable alkaline batteries

3. Rechargeable NiMH batteries

There are four battery slots. Slots 1 and 2 form one group ("1" will be marked on the

holder), while slot 3 and 4 form the other group ("2" will be marked on the holder) where

each group can supply power individually.

When in Test Mode, the camera will automatically shut down to save power if no

operations are performed within 3 minutes; it can be turned back on by any kind of motion

detection.

When in a low-battery state, the camera will be automatically shut down. Please

change the batteries at this time.

Insert a SD-card into the card slot with contacts facing the front of the camera.

Please note that the SD-card can only be inserted in one direction. Make sure that

the write-protection "Lock" switch of the SD-card is in the "Write" position (not locked).

Before switching the camera on, please pay attention to the following:

1. Avoid temperature and motion disturbances that could be mistaken as animals or

humans such as trees that are exposed to direct sunlight for much of the day or any other

heat source. These may cause false triggers.

2. The camera should be placed about 1 meter (3 feet) from the ground. As an

example for deer, waist height is a good height. In general, one to two meters (3 – 6 feet)

in height is preferred.

Slide the power switch to the ON position to power on the camera.

After switching on the camera, the motion indication LED (red) will blink for about

15 seconds. The 15 second timer is a buffer before the camera starts to capture photos or

videos, e.g. for closing and locking the bottom cover, fixing the camera on a tree, or

walking away from the area being monitored.

When powered on, the camera will take pictures or videos automatically according

3. Easy Operation