Amcrest ATC-801 Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Câmara digital Amcrest ATC-801. Amcrest ATC-801 15 páginas. Digital game & trail hunting camera
Imprimir página
3.1 Power Supply
To supply power to the camera, four or eight AA size batteries are needed.
Open the bottom cover. Confirm that the power switch is in the OFF (right) position,
pull out the battery holder. Load the fully charged batteries into the holder according to
the polarity shown below. Push the battery holder back into the battery chamber.
The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline batteries (Recommended)
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
There are four battery slots. Slots 1 and 2 form one group ("1" will be marked on the
holder), while slot 3 and 4 form the other group ("2" will be marked on the holder) where
each group can supply power individually.
When in Test Mode, the camera will automatically shut down to save power if no
operations are performed within 3 minutes; it can be turned back on by any kind of motion
detection.
When in a low-battery state, the camera will be automatically shut down. Please
change the batteries at this time.
3.2 Insert the SD-card
Insert a SD-card into the card slot with contacts facing the front of the camera.
Please note that the SD-card can only be inserted in one direction. Make sure that
the write-protection "Lock" switch of the SD-card is in the "Write" position (not locked).
3.3 Power on and Enter the ON Mode
Before switching the camera on, please pay attention to the following:
1. Avoid temperature and motion disturbances that could be mistaken as animals or
humans such as trees that are exposed to direct sunlight for much of the day or any other
heat source. These may cause false triggers.
2. The camera should be placed about 1 meter (3 feet) from the ground. As an
example for deer, waist height is a good height. In general, one to two meters (3 – 6 feet)
in height is preferred.
Slide the power switch to the ON position to power on the camera.
After switching on the camera, the motion indication LED (red) will blink for about
15 seconds. The 15 second timer is a buffer before the camera starts to capture photos or
videos, e.g. for closing and locking the bottom cover, fixing the camera on a tree, or
walking away from the area being monitored.
When powered on, the camera will take pictures or videos automatically according
3. Easy Operation
4