ACR STOVES NOVUS 기술 매뉴얼 - 페이지 6

{카테고리_이름} ACR STOVES NOVUS에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR STOVES NOVUS 17 페이지.

Novus manual 0916-1 24/11/2016 13:43 Page 6

This appliance is equipped with a pre-fitted manufacturers smoke exempt stop. Under

no circumstances should it be tampered with or removed unless expressly authorised

by a competent person and the appliance is not installed in a smoke exempt area.

If the appliance is to be installed in a non smoke exempt area you can remove the

restricting screw on the air control wheel to allow full movement.

The appliance is supplied pre-assembled with the flue spigot in the top exit

position.

• If using a top exit flue connection please ensure that the ceramic top casting is

fitted BEFORE the flue connection is made.

If you intend to install the appliance using a rear flue connection, the blanking

plate should be swapped over as follows:

Heat shield installation:

Assembly of the unit

• Remove the outer blanking plate

• Remove the inner blanking plate

two bolts

• Remove the flue spigot from the top exit by removing

the securing bolts and rope seal

• Refit the rope seal and flue spigot to the rear exit and

secure with the bolts.

• Refit the blanking plate to the top exit using the rope

seal and retaining bolts.

• Insert cosmetic ceramic blanking plate into the

ceramic top recess

• Please fit the included heat shield (see

attached diagram).

The heat shield must be fitted on all

installation occasions without exception.

in the rear panel

by removing the