Flomec QS200 제품 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Flomec QS200에 대한 제품 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Flomec QS200 16 페이지. Insertion ultrasonic flowmeter options for large pipe sizes
Flomec QS200에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 제품 소유자 매뉴얼 (20 페이지)

페이지 인쇄

INSTALLATION ( CONTINUED )

Place the marked sleeve back into saddle, engaging the threaded studs to the depth

marked. Twist the bottom nuts upward to bottom of sleeve flange, replace the two nuts

removed earlier and tighten all nuts with 7/16 wrench. See Figure 5.

TIGHTEN DOWNWARD

TIGHTEN UPWARD

PERMANENT MARK

Figure 5

Step 4 – Mounting the Sensor:

Note the flow arrows on the side of the sensor, these must point downstream. Insert sensor

into sleeve, press down until hole in sensor matches hole in sleeve. Insert retention pin.

Final sensor depth should match that shown in Figure 6.

.060

.030

Figure 6

TIGHTEN DOWNWARD

TIGHTEN UPWARD