Acer 226HQL 사용자 설명서 - 페이지 15

{카테고리_이름} Acer 226HQL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer 226HQL 28 페이지. User manual

Connecting the power cord

•

Check first to make sure that the power cord you use is the correct type

required for your area.

•

The monitor has a universal power supply that allows operation in either

100/120 V AC or 220/240 V AC voltage area. No user-adjustment is

required.

•

Plug one end of the power cord to the AC inlet, and plug the other end

into an AC outlet.

•

For units using 120 V AC:

Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.

•

For units using 220/240 V AC:

Use a cord set consisting of H05VV-F cord and plug rated 10 A/250 V. The

cord set should have the appropriate safety approvals for the country in

which the equipment will be installed.

The monitor will be switched to "power saving" mode by the control signal

from the display controller, as indicated by the amber-colored power LED.

Power saving

The power saving mode will be kept until a control signal has been detected or

the keyboard or mouse is activated. The recovery time from "power saving"

mode back to "on" is around 3 seconds.

To make installation easier, so long as your system supports the DDC protocol,

the monitor is able to plug-and-play. The DDC is a communication protocol

through which the monitor automatically informs the host system about its

capabilities; for example, supported resolutions and corresponding timing. The

monitor supports the DDC2B standard.

Mode

LED light

Blue

Amber