Coastal Paragon NEO ANGLE w/Bi-fold 매뉴얼 - 페이지 4

{카테고리_이름} Coastal Paragon NEO ANGLE w/Bi-fold에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coastal Paragon NEO ANGLE w/Bi-fold 8 페이지.

페이지 인쇄

Mark Curb Centerline & Measure Segments

Pencil mark the curb centerline as shown. Measure the left, center

and right segment lengths and jot down their measurements in the

spaces provided below. These are critical dimensions, so make

sure to double-check your measurements.

M E A S

U R E

T O I

N T E R

S E C T

I O N

left segment length _____+ 1" = left Sill trim length

right segment length _____+ 1" = right Sill trim length

center segment length ____+ 9/16" = center Sill trim length

Trim Sill Pieces

Sill (A) and Header (B) pieces are identical in appearance except for

the weep holes on the Sill pieces (Sill pieces have weep holes;

Header pieces do not). Trim the Sill pieces to the lengths specified

in step 1.

Assemble and Position Sill on Curb

Assemble Sill (A) by inserting Corner Brackets (R) into Sill pieces

and bringing the pieces together (see figure above and exploded

view - sheet 3).

Using the Corner Bracket holes as guides, mark and drill the Sill

pieces with a 1/8" drill bit. Secure the Corner Brackets to the Sill

pieces with eight(8) #6 x 1/4" machine screws (S). Now run a bead

of caulking on inside of crevice where Sill pieces join to insure no

leaks. Position Sill on curb. Temporarily tape Sill to curb to prevent

movement.

E T

S U R

M E A

E C T

E R S

ME AS UR E

I N T

Position and Install Wall Jambs

I O N

Place Wall Jambs (D) into ends of Sill (A) and up against the shower

walls as shown. Plumb the Jambs, then pencil mark the installation

hole locations on the shower walls (3 per Jamb). Remove Wall

jambs. Using a 3/16 masonry bit, drill 1-1/4" deep installation holes

in locations previously marked. Insert Plastic Screw Anchors (P)

into holes. Reposition Jambs as before and secure to wall using

six(6) 8112P Installation Screws (O)

Install Glass Panels

Insert glass support Setting Blocks (Q) into the Sill cavity as shown.

Set the Glass Panels (U) on the Setting Blocks and slide Glass

Panels a 1/2" into its respective Wall Jamb (D). Hold panels in place

by inserting a short piece of Glazing Vinyl (V) between Glass Panels

and the Wall Jambs, both inside and out.

Install 45 degree Corner Posts

Glass Panels must have a 1/2" insertion into their Wall Jamb and the

45 degree Corner Post in order for glazing vinyl to hold glass

properly.

Slide 45 degree Corner Posts (E) over the exposed edge of the

Glass Panels and set them into Sill cavity as shown. Double check

for 1/2" insertion before proceeding.

( 4 )