Coastal Paragon NEO ANGLE w/Bi-fold 매뉴얼 - 페이지 6
{카테고리_이름} Coastal Paragon NEO ANGLE w/Bi-fold에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coastal Paragon NEO ANGLE w/Bi-fold 8 페이지.
Install Magnet Holder
Install Magnet Holder Assembly (I) onto the bottom rail (g4) of the
"hinge side door" as shown in exploded view - sheet 3.
Note that Magnet Holder Assembly is installed as close to Center
Hinge Pull (g5) as possible. Magnet (i2) must face toward the out-
side of the shower enclosure as shown in figure.
Install Door Assembly
Pick the Door Assembly up. Now fold the Door Assembly making
sure that assembly folds in toward the shower enclosure as shown
in figure.
Insert the Door Assembly's top and bottom Bushings (M) into cavi-
ties of the top and bottom Guide Tracks (C). Positioning the Door
Assembly diagonally to the door opening will help ease Bushing
insertion.
Once top and bottom Bushings are engaged with the top and bot-
tom Guide Tracks . . . insert the Door Assembly's Hinge Post (g1)
into the Corner Post (E) from which it is to swing (see figure and
exploded view - sheet 3). Remember that regardless of whether the
door strikes on the left side or the on the right side . . . the Door
Assembly must always fold in toward interior of shower enclosure.
Temporarily leave as is.
Attach Door Handles
Attach the Door Handles (J) to the door using two(2) Door Handle
Screws (K) as shown in exploded view - sheet 3.
Adjust Door Assembly
Step inside the shower enclosure and close the Door. Adjust Door
Assembly (G) and Strike Post (F) as needed for proper Door opera-
tion.
Note: Door Assembly (G) bottom must always remain parallel to Sill
(A) in order for door to operate properly. Check to make sure that
bottom of Door Assembly is parallel to the Sill. If it is not, make it so.
When satisfied with door operation, secure Hinge Post (g1) and Strike
Post (F) to the vertical posts using six(6) 638PHPT Installation Screws
(T). See exploded view - sheet 3.
Install Drip Rails
Clean bottom rails of Door Assembly with alcohol to remove any oil.
Failure to clean door rails prior to installation of Drip Rails (H) may
cause tape to release.
Remove backing from tape and position Drip Rails flush with edges
of Hinge Stiles (g2) as shown in figure above and flush with bottom
of Door as shown in figure below.
( 6 )