Coastal Paragon NEO ANGLE w/Bi-fold Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Armatura łazienkowa Coastal Paragon NEO ANGLE w/Bi-fold. Coastal Paragon NEO ANGLE w/Bi-fold 8 stron.

Drukuj stronę

Install Magnet Holder

Install Magnet Holder Assembly (I) onto the bottom rail (g4) of the

"hinge side door" as shown in exploded view - sheet 3.

Note that Magnet Holder Assembly is installed as close to Center

Hinge Pull (g5) as possible. Magnet (i2) must face toward the out-

side of the shower enclosure as shown in figure.

Install Door Assembly

Pick the Door Assembly up. Now fold the Door Assembly making

sure that assembly folds in toward the shower enclosure as shown

in figure.

Insert the Door Assembly's top and bottom Bushings (M) into cavi-

ties of the top and bottom Guide Tracks (C). Positioning the Door

Assembly diagonally to the door opening will help ease Bushing

insertion.

Once top and bottom Bushings are engaged with the top and bot-

tom Guide Tracks . . . insert the Door Assembly's Hinge Post (g1)

into the Corner Post (E) from which it is to swing (see figure and

exploded view - sheet 3). Remember that regardless of whether the

door strikes on the left side or the on the right side . . . the Door

Assembly must always fold in toward interior of shower enclosure.

Temporarily leave as is.

Attach Door Handles

Attach the Door Handles (J) to the door using two(2) Door Handle

Screws (K) as shown in exploded view - sheet 3.

Adjust Door Assembly

Step inside the shower enclosure and close the Door. Adjust Door

Assembly (G) and Strike Post (F) as needed for proper Door opera-

tion.

Note: Door Assembly (G) bottom must always remain parallel to Sill

(A) in order for door to operate properly. Check to make sure that

bottom of Door Assembly is parallel to the Sill. If it is not, make it so.

When satisfied with door operation, secure Hinge Post (g1) and Strike

Post (F) to the vertical posts using six(6) 638PHPT Installation Screws

(T). See exploded view - sheet 3.

Install Drip Rails

Clean bottom rails of Door Assembly with alcohol to remove any oil.

Failure to clean door rails prior to installation of Drip Rails (H) may

cause tape to release.

Remove backing from tape and position Drip Rails flush with edges

of Hinge Stiles (g2) as shown in figure above and flush with bottom

of Door as shown in figure below.

( 6 )