Acer AL1531 사용자 설명서 - 페이지 2

{카테고리_이름} Acer AL1531에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer AL1531 8 페이지. Acer al1531: user guide

페이지 인쇄

Important Safety Instructions

Please read the following instructions carefully. This manual should be retained for future use.

1. To clean LCD Monitor screen;

-- Power off LCD Monitor and unplug the AC Cord.

-- Spray a non-solvent cleaning solution onto a rag.

-- Gently clean the screen with dampened rag.

2. Do not place the LCD Monitor near a window. Exposing the monitor to rain water, moisture or sunlight can

severely damage it.

3. Do not apply pressure to the LCD screen. Excess pressure may cause permanent damage to the display.

4. Do not remove the cover or attempt to service this unit by yourself. Servicing of any nature should be

performed by an authorized technician.

5. Store LCD Monitor in a room with a room temperature of -20° ~ 60°C (or -4° ~ 140°F). Storing the LCD

Monitor outside this range could result in permanent damage.

6. If any of the following occurs, immediately unplug your monitor and call an authorized technician.

* Monitor to PC signal cable is frayed or damaged.

* Liquid spilled into LCD Monitor or the monitor has been exposed to rain.

* LCD Monitor or the case is damaged.

7. A certified line is required to connect this device to a power outlet. For a nominal current up to 6A and a device

weight above 3 kg, a line not lighter than H05VV-F, 3G, 0.75 mm

8. For use only with power supply LINEARITY LAD6019AB4 and Li-shin, LSE0218B1260.

Chapter 1 Installation

Unpacking

Before unpacking the LCD Monitor, prepare a suitable workspace for your Monitor and computer. You need a

stable and clean surface near a wall power outlet. Make sure that LCD Monitor has enough space around it for

sufficient airflow. Though the LCD Monitor uses very little power, some ventilation is needed to ensure that the

Monitor does not become too hot.

After you unpack the LCD Monitor, make sure that the following items were included in the box:

* LCD Monitor

* 1.8M Monitor-to-PC VGA Cable

* 1.8M Monitor-to-PC DVI-D Cable

* 1.8M Stereo Jack Audio Cable

If you find that any of these items is missing or appears damaged, contact your dealer immediately.

Connecting the LCD Monitor and Base

When you open the box to take the base and put on the desk first. Then connect

the LCD Monitor and base and screw it locked please. (See fig.1-1 )

Viewing Angle Adjustment

The LCD Monitor is designed to allow users to have a comfortable

viewing angle. The viewing angle can be adjusted from -5°to

+20°.(See fig. 1-2).

Warning: Do not force the LCD Monitor over its maximum viewing angle settings as stated above.

Attempting this will result in damaging the Monitor and Monitor stand.

must be used.

* User's Manual

* AC Adapter

* 1.8M Power Cord

Figure 1-1

Figure 1-2