Acer AL1531 사용자 설명서 - 페이지 3

{카테고리_이름} Acer AL1531에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer AL1531 8 페이지. Acer al1531: user guide

Detaching LCD Monitor from Its Stand

Unscrew screws

the swivel base support column and pull it from main

body.

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded

nuts, as well as four 5 mm access holes in the plastic covering as illustrated in

Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical

Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13

November 1997).

Note :Please using Ø 4mm x 8mm (L) screw for this application

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor's VGA port or DVI

port.(See Fig 1-5)

3. Connect the other end of the signal cable to the VGA port or DVI port on

your PC.

4. Make sure connection are secure.

Attention: This device must be connected to an off-the-shelf video cable in order to comply with FCC

regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

1. Connect the power cord to the AC adapter.(See Fig. 1-6)

2. Connect the AC adapter's DC output connector to the DC Power Jack of the

monitor.

3. Connect the power cord to an AC power source.

Warning:

We recommand to install a "Surge Protector" device between the AC Adapter and the electrical wall

outlet for adding protection against power surges to prevent the errects of sudden voltage variations from reaching

the LCD Monitor. Sudden power surges may damage your monitor.

1. Connect the audio cable to the " LINE OUT " jack on your PC's audio card

or to the front panel's "AUDIO OUT" jack of your CD ROM drive. (See

Fig. 1-7)

2. Connect the other end of the audio cable to the LCD Monitor's " LINE IN

" jack.

Figure 1-3

Figure 1-4

Figure 1-6

Figure 1-7