Aktakom ATA-2504 사용자 설명서 - 페이지 5

{카테고리_이름} Aktakom ATA-2504에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ATA-2504 9 페이지. Clamp meter

II. Panel Description

tactile barrier

1. Transformer Jaw

To measure DC/AC current, enclose the conductor by the jaw.

2. Transformer Trigger

Push the trigger to open the jaw.

3. Zero Button

Push the zero button to zero the output voltage before measuring any current.

4. On/Off and Range Selection Switch

Turn the rotary switch to select the desired range.

5. Power-on LED

When the unit is turned on, this LED will be lighted.

6. Low Battery LED

When the battery voltage is lower than the required voltage, this LED will be lighted

while the power-on LED will be off.

7. Output Terminals

The output voltage is proportional to the current measured. Black terminal is the

signal ground while red terminal is the signal. Do not input any live voltage to

these terminals.

8. Hand Strap

Put your hand through the hole of the hand strap to avoid accidental drop of the

clamp meter.