Acer AL1916 사용자 설명서 - 페이지 3

{카테고리_이름} Acer AL1916에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer AL1916 16 페이지. Value line
Acer AL1916에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지), 사용자 설명서 (10 페이지), 사양 (2 페이지), 서비스 매뉴얼 (40 페이지), 서비스 매뉴얼 (47 페이지), 서비스 매뉴얼 (37 페이지), 서비스 매뉴얼 (47 페이지)

Important Safety Instructions

Please read the following instructions carefully. This manual should be retained for future use.

1. To clean LCD Monitor screen;

-- Power off LCD Monitor and unplug the AC Cord.

-- Spray a non-solvent cleaning solution onto a rag.

-- Gently clean the screen with dampened rag.

2. Do not place the LCD Monitor near a window. Exposing the monitor to rain water, moisture or

sunlight can severely damage it.

3. Do not apply pressure to the LCD screen. Excess pressure may cause permanent damage to the

display.

4. Do not remove the cover or attempt to service this unit by yourself. Servicing of any nature should

be performed by an authorized technician.

5. Store LCD Monitor in a room with a room temperature of -20° ~ 60°C (or -4° ~ 140°F). Storing the

LCD Monitor outside this range could result in permanent damage.

6. If any of the following occurs, immediately unplug your monitor and call an authorized technician.

* Monitor to PC signal cable is frayed or damaged.

* Liquid spilled into LCD Monitor or the monitor has been exposed to rain.

* LCD Monitor or the case is damaged.

7. Only use the supplied main lead to connect the monitor. For a nominal current up to 6A and a

device weight above 3 kg, a line not lighter than H05VV-F, 3G, 0.75 mm

The following symptoms are normal with LCD monitor and do not indicate a problem.

NOTES

•

Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the

Power Switch and then turn it on again to make sure the flicker disappears.

•

You may find slightly uneven brightness on the screen depending on the desktop pattern you use.

•

The LCD screen has effective pixels of 99.99% or more. It may include blemishes of 0.01% or less

such as a missing pixel or a pixel lit all of the time.

•

Due to the nature of the LCD screen, an afterimage of the previous screen may remain after

switching the image, when the same image is displayed for hours. In this case, the screen is

recovered slowly by changing the image or turning off the Power Switch for hours.

must be used.