aero-naut Princess 사용 설명서 - 페이지 3
{카테고리_이름} aero-naut Princess에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. aero-naut Princess 17 페이지. 3081/00
5
Position the plywood template 18 between
frames 3 + 4 to ensure that the whole
structure is "square". Glue all the corner
joints involving parts 1 - 13. Do not glue the
template 18 in place, as this is removed again
at a later stage.
16
12
Insert the two curved deck support
6
formers 16 in the notches in the keel 12
and frame 11; it should also rest on the
brace 15.
17
11
13
13
5
6
7
11
15
16
7
Bevel the central edge of the rear keel components 14
so that they fit snugly in the notches in frames 1 and
3 - 5, then glue them in place.
6
17
7
8
9
10
1
3
4
18
3
4
The curved formers 16 must not project beyond
the keel 12 and frame 11.
8
Glue the rails 17 to frames 1 - 11; parts 17 must be pressed
1
fully into the notches in the frames; this is particularly
important at frame 11 at the bow. Use modelling pins to hold
2
3
the rails 17 in place.
4
5
Insert the two fore-and-aft bearers 13 in the slots
4
in frames 1 and 3 - 7, and press them fully into the
notches; note that the bearers 13 must not project.
Press frame 1 against the bearers 13 from the rear.
16
12
14
17
11
16
11
14
1
3
4
5