aero-naut Princess 사용 설명서 - 페이지 6

{카테고리_이름} aero-naut Princess에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. aero-naut Princess 17 페이지. 3081/00

Caution: take care to identify the left

and right sides during the next stage.

Chamfer the inside (centreline) edge

of both hull bottom panels 24 (see

arrows), to produce a sharp edge on

the outside of the joint. Lay the two

bottom panels 24 flat on the bench

and tape them together as shown.

Lay the bottom panels 24 on the hull and

tape them to the structure starting from the

rear on the right-hand side, ensuring that the

edges meet accurately along the centre. At

the bow there will be a gap about 6 mm

wide, as the material is too stiff to

accommodate the curvature.

Apply more glue to the joints

between the side panels 23 and the

frames and stringers from the inside

of the hull.

Do not apply glue at this

stage!