Aktakom ASE-1112 사용 설명서 - 페이지 5

{카테고리_이름} Aktakom ASE-1112에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ASE-1112 6 페이지. Temperature controlled soldering station

CAUTION!

Handle the heated soldering iron with extreme care, as the

high temperature of the iron can cause fires or painful bums.

The first time you use the soldering iron, it may smoke

slightly as the heating element dries out. This is normal and

should onty last for approx. 10 minutes.

Never file the specially-plated tip.

MAINTENANCE

This tool must be placed on its stand when not in use.

If the supply cord is damaged, it must be replaced by the manufacturer or its

service agent or a similarly qualified person in order to avoid hazard.

Note: Tip replacement or cleaning should be done only when the iron is at room

temperature or below. The tip can be changed or replaced simply by

unscrewing the knurled nut barrel assembly. The station must be switched off

and allowed to cool down before and during this operation, as damage may

occur if the system is left on without the tip inserted. After removing tip

remove any oxide dust that may have formed in the tip retaining area of the

barrel. Be careful to avoid getting dust in your eyes. Replace the tip and screw

the retaining knurled nut barrel assembly using only hand pressure to tighten.

Pliers should only be used to tighten the nut if loosening occur when the iron is

hot to avoid burning your fingers. Do not over tighten as this would damage the

element.