Aktakom ASE-4509 사용자 설명서 - 페이지 3

{카테고리_이름} Aktakom ASE-4509에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ASE-4509 8 페이지. Smd rework station

2. Operating Instructions

2.1 Before Operation

• Select the appropriate FP Pick-up Wire that

matches the size of the IC. The Fp Pick-up has an S

wire (14mm) attached to it, an L wire (30mm) may

also be needed, depending on the size of the IC.

• Select the appropriate Nozzle that matches the

size of the IC.

• Loosen the screw on the nozzle , insert the Nozzle

into the top, then fasten the screw properly.

2.2 The display and temperature setting

1. Press the button "+" or "-"to adjust the

temperature. In short press, the set-point will change

±1°C In long press, the set-point will change quickly

and reach your target temperature.

2."* " is the transfer button between °C/°F. The

default unit is °C, press the "* "button to make change

between °C and °F.