Aero-Spa AP 1000 설치 매뉴얼 - 페이지 9

{카테고리_이름} Aero-Spa AP 1000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aero-Spa AP 1000 12 페이지.
Aero-Spa AP 1000에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지)

If you substitute swimming pool chlorine (10% – 15% sodium

hypochlorite) you would need about half as much.

The suggested method on fill and start-up would be to use sodium

dichlor on the initial application of the sanitizer and then the first time

you need to adjust the free chlorine. Any subsequent time the free

chlorine needs to be adjusted use 0.63 OZ (1.25 tablespoons) of

regular household bleach (6% sodium hypochlorite). The reason for

this is that the sodium dichlor contains cyanuric acid (CYA) as a

stabilizing agent. The CYA keeps the chlorine from degrading. If you

continue to use soduim dichlor to raise the free chlorine, over time the

CYA builds up in the water and makes the chlorine ineffective. The

initial application of sodium dichlor will have enough CYA to stabilize

the chlorine for the long run. This method will minimize maintenance

and save you money! The easy formula is first and second application

is sodium dichlor and all others bleach.

Aero-Spa™ not running

1. Reset GFCI breaker. If this problem persists replace GFCI

breaker

2. Reset circuit breaker at house fuse panel. If this problem

persists call Aero-Spa™, LLC

3. Bypass timer, if this corrects the problem replace timer

4. If these steps do not solve the problem call Aero-Spa™, LLC

Water is cloudy

1. Increase the run time cycle

2. Repeat step 1 until water clarity improves

3. If these steps do not solve the problem call Aero-Spa™, LLC

No bubbles coming from sintered diffuser

1. Verify Aero-Spa™ is running

2. Verify ozone tube is not broken

3. Verify ozone tube is not pinched or disconnected

4. If these steps do not solve the problem call Aero-Spa™, LLC

Strong ozone odor near Aero-Spa™

1. Verify ozone tube is not broken

2. Verify ozone tube is not pinched or disconnected

3. Turn off air pump and call Aero-Spa™, LLC

TROUBLESHOOTING