Aero-Spa AP 1000 설치 매뉴얼 - 페이지 9

{카테고리_이름} Aero-Spa AP 1000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aero-Spa AP 1000 13 페이지.
Aero-Spa AP 1000에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)

Aero-Spa not running / No bubble from sintered diffuser

1. Verify unit is receiving power

a. Reset GFCI breaker.

b. Reset circuit breaker at house fuse panel.

2. Bypass timer, if this corrects the problem, replace timer

3. Verify ozone tube is not broken, pinched, or disconnected

4. If these steps do not solve the problem call Aero-Spa, LLC

A condition typically associated with organic particulates from oils,

soaps, or materials inside piping of the hot tub.

1. Increase runtime by (2) hours. Synchronize circulation pump

and Aero-Spa run time.

2. If not resolved within (4) days, contact Aero-Spa, LLC

Strong ozone odor near Aero-Spa generator

1. Verify ozone tube is not broken

2. Verify ozone tube is not pinched or disconnected

3. Unplug unit and call Aero-Spa, LLC

1. Reduce cycle run time by 25%. Repeat if odor remains strong

after 1 hour.

2. Unplug unit and call Aero-Spa, LLC

Ozone tube is cloudy in color and not flexible

This is normal, periodically check for cracks in ozone tube.

Replacement parts are available from Aero-Spa, LLC

This is a result of the ozone precipitating the iron out of the water. It

will not cause any issues with the operation of the diffuser. This

typically occurs when the water used to fill the hot tub has high iron

content. The diffuser can be soaked in "rust or stain remover" or

similar product and rinsed thoroughly after soaking.

TROUBLESHOOTING

Water is cloudy

Strong ozone odor in hot tub

Sintered diffuser is turning brown